Whistle Crew Wiki

* Setting a speed multiplier at certain layers

Increase Acceleration speeds to reduce overall print time. Have doubled the following acceleration speeds on a P1S. Normal Printing (20000 mmm/s)/Travel (20000mm/s)/Outer wall (10000 mm/s)/Top surface (4000 mm/s)

Try increasing “Other layers” Speed by 133% or 166% to reduce overall print time, including Outer Wall, Inner Wall, Sparse Infill, Internal solid infill, Top surface, Gap infill

Alternatively, give Bambu's Sport Mode or Ludicrous Mode a try. This can be set after the print has started in Bambu Handy or on the Device tab in Bambu Studio

Try increasing your layer height. For .4mm nozzles, you can increase the layer height to .24mm or .28mm. If you do increase the layer height, it's recommended to do a layer height adjustment at bridge layers to .20mm with 100% infill to increase the strength of the bridge.