wiki:troubleshooting_bed-adhesion-tips
Differences
This shows you the differences between two versions of the page.
| Next revision | Previous revision | ||
| wiki:troubleshooting_bed-adhesion-tips [2026/01/21 00:45] – created page samurailink3 | wiki:troubleshooting_bed-adhesion-tips [2026/01/26 19:28] (current) – [Other Tips and Tricks] dc | ||
|---|---|---|---|
| Line 17: | Line 17: | ||
| Dehydrating a roll of filament can sometimes be enough to bring it back to life. | Dehydrating a roll of filament can sometimes be enough to bring it back to life. | ||
| + | ==== Other Tips and Tricks ==== | ||
| + | Some tips from other Whistle Crew volunteers: | ||
| + | * Increasing wall count to " | ||
| + | * For PLA, set/reduce initial lay print speeds to 30mm/s and 70mm/s for the first layer infill | ||
| + | * Increasing the first layer bed temp 5c to 10c, for example increase to 60-65c (from 55c) for PLA on a textured PEI plate | ||
| + | * For Silk PLA, set Initial Layer Speed to 20mm/s, bump first layer bed temp to 75c and the rest at 70c | ||
| + | * Use nitrile-coated gloves when handling the build plate to keep it free from finger oils | ||
wiki/troubleshooting_bed-adhesion-tips.1768956359.txt.gz · Last modified: by samurailink3