wiki:process_slicer-tips-and-tricks_setting-speed-multiplier-per-layer
Differences
This shows you the differences between two versions of the page.
| wiki:process_slicer-tips-and-tricks_setting-speed-multiplier-per-layer [2026/01/24 07:24] – created bb3d | wiki:process_slicer-tips-and-tricks_setting-speed-multiplier-per-layer [2026/01/24 07:27] (current) – bb3d | ||
|---|---|---|---|
| Line 2: | Line 2: | ||
| | | ||
| Some people find that setting the printer speed multiplier to 80%-100% during bridging, top/bottom layers, and then setting it to 150%+ during everything else, has lead to faster prints. YMMV. Below is how you set the speed multiplier (or any custom gcode) at a specific layer height. | Some people find that setting the printer speed multiplier to 80%-100% during bridging, top/bottom layers, and then setting it to 150%+ during everything else, has lead to faster prints. YMMV. Below is how you set the speed multiplier (or any custom gcode) at a specific layer height. | ||
| + | |||
| + | [[https:// | ||
| | | ||
| | | ||
wiki/process_slicer-tips-and-tricks_setting-speed-multiplier-per-layer.1769239473.txt.gz · Last modified: by bb3d