Whistle Crew Wiki

* Setting a speed multiplier at certain layers

Increase Acceleration speeds to reduce overall print time. Have doubled the following acceleration speeds on a P1S. Normal Printing (20000 mmm/s)/Travel (20000mm/s)/Outer wall (10000 mm/s)/Top surface (4000 mm/s)

Try increasing “Other layers” Speed by 133% or 166% to reduce overall print time, including Outer Wall, Inner Wall, Sparse Infill, Internal solid infill, Top surface, Gap infill

Alternatively, give Bambu's Sport Mode or Ludicrous Mode a try. This can be set after the print has started in Bambu Handy or on the Device tab in Bambu Studio