Differences

This shows you the differences between two versions of the page.

--- wiki:process_slicer-tips-and-tricks [2026/01/27 06:42] – Use horizontal images billiam
+++ wiki:process_slicer-tips-and-tricks [2026/01/27 09:02] (current) – corrected "100% infill to increase the strength of the bridge" to "100% infill/wall overlap to increase the strength of the bridge" speedwhistles
@@ Line 5: / Line 5: @@
   * Increase **"Other layers" Speed** by 133% or 166% to reduce overall print time, including Outer Wall, Inner Wall, Sparse Infill, Internal solid infill, Top surface, Gap infill
   * Alternatively, give Bambu's Sport Mode or Ludicrous Mode a try. This can be activated after the print has started in Bambu Handy, on the Device tab in Bambu Studio, or automatically set in your slicer by [[process_slicer-tips-and-tricks_setting-speed-multiplier-per-layer|Adjusting Print Speed at a Layer Height]]
-  * Increase **Layer Height**. For .4mm nozzles, you can increase the layer height to .24mm or .28mm. If you do increase the layer height, it's recommended to do a layer height adjustment at bridge layers to .20mm with 100% infill to increase the strength of the bridge. Video tutorial in Bambu Studio: {{ :wiki:bridgelayerheightmodification.mp4 |Video tutorial in Bambu Studio}}
+  * Increase **Layer Height**. For .4mm nozzles, you can increase the layer height to .24mm or .28mm. If you do increase the layer height, it's recommended to do a layer height adjustment at bridge layers to .20mm with 100% infill/wall overlap to increase the strength of the bridge. Video tutorial in Bambu Studio: {{ :wiki:bridgelayerheightmodification.mp4 |Video tutorial in Bambu Studio}}
 ==== Bridging ====