Differences

This shows you the differences between two versions of the page.

--- wiki:troubleshooting_bed-adhesion-tips [2026/01/22 21:04] – [Other Tips and Tricks] Optimized tip from chat samurailink3
+++ wiki:troubleshooting_bed-adhesion-tips [2026/01/26 19:28] (current) – [Other Tips and Tricks] dc
@@ Line 21: / Line 21: @@
   * Increasing wall count to "3"
-  * Reducing initial lay print speeds to 30 and 70 for the first layer infill
+  * For PLA, set/reduce initial lay print speeds to 30mm/s and 70mm/s for the first layer infill
-  * Increasing the first layer bed temp to 60-65 (from 55) for PLA on a textured PEI plate
+  * Increasing the first layer bed temp 5c to 10c, for example increase to 60-65c (from 55c) for PLA on a textured PEI plate
+  * For Silk PLA, set Initial Layer Speed to 20mm/s, bump first layer bed temp to 75c and the rest at 70c
   * Use nitrile-coated gloves when handling the build plate to keep it free from finger oils