wiki:troubleshooting_whistle-malfunctions
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |||
| wiki:troubleshooting_whistle-malfunctions [2026/01/28 20:21] – [So a whistle will most likely fail at] bb3d | wiki:troubleshooting_whistle-malfunctions [2026/01/28 20:22] (current) – [Practical things to check] bb3d | ||
|---|---|---|---|
| Line 26: | Line 26: | ||
| * You always want to "paint on" seams away from any of the above components | * You always want to "paint on" seams away from any of the above components | ||
| * If the blade is not sharp | * If the blade is not sharp | ||
| - | * Points to a Pressure Advance or flow issue | + | * Points to a Pressure Advance, cooling, |
| * If there are holes in the chamber walls or walls of the whistle, allowing air to escape | * If there are holes in the chamber walls or walls of the whistle, allowing air to escape | ||
| * Could be flow, seam, or retraction issue | * Could be flow, seam, or retraction issue | ||
wiki/troubleshooting_whistle-malfunctions.1769631712.txt.gz · Last modified: by bb3d